Snubber bracket and poly mount kit, fits most 5-cylinder cars, greatly reduces engine movement w/o increasing ride harshness. A dramatic improvement for the investment. Poly mount fits very tightly in bracket to reduce any slop from the drivetrain.
Fits 4000 Quattro, 80/90/Coupe Quattro, UrQuattro and others. Does not include brackets for Aux radiator, if you are still using it brackets can be easily fabbed up using some strap aluminum.
NOTE: When installing this poly mount in an 034Motorsport Snubber Bracket, some light trimming of the outside of the mount is required to make it a perfect fit, this can easily be accomplished with a utility knife.
Also, an Install tip posted by a customer:
"Tricks are as follows:
1- Get everything off the front end (obviously) so the snub is exposed
2- Nuke (that's right I said microwave) the snub mount for 10 seconds at a time (maybe less in more powerful micro, check every 15sec max)... makes it nice and toasty and just soft enough just a tiny bit of body weight pushes it right on (so sweet) [Note, if you melt the shit out of your mount 034Motorsport will not be responsible, so be careful!!]
3- Let it cool a bit so it doesn't get lodged in the bracket and come off the post attached to the motor, being so pliable
4- WD40 the poly snub mount
5- Push the bottom half of the snub bracket halfway onto the mount leaving the part where the cylinder pokes over the edge of the plate off and get a clamp and tighten it down until the bracket is on
6- Push all the way on and reassemble
7- Have a shit eating grin on your face when you realize all the slop in the tranny and motor/front end is gone when you shift and get on it
8- Come home and have a beer and smile knowing you just did a nice, easy quick job and it was one of the best $90 spent on the car" - Thanks Peter!