Cam Gear, Autotech, Audi I5 20v or VW 16v and 058 1.8T
Cam gear is CNC-crafted entirely from both 6061 & 7075-T6 aluminum. The main portion including the teeth is hard-anodized for durability. The inner hub is anodized red. All factory timing marks are on the gear, to ensure simple, accurate installation. All marks are laser engraved. The gear is held firmly in your desired setting with ARP stainless flange-head screws.
The gear is marked for 10 degrees advance or retard of the camshaft timing. You can correctly "zero-in" (degree) your camshaft to the recommended setting with ease. In general, advancing the cam timing increases low-end torque and improves throttle response. Retarding the camshaft timing will generally shift the powerband upward, increasing top-end power. This is also good when installing a resurfaced head, because the gear can be used to correct for timing loss (retardation) caused by the cam being closer to the crankshaft. This gear will allow you to adjust for the peak performance and power range desired. Weighs a scant 14 ounces. Fits 1.8L & 2.0L 16V gas engines in Mk1 and Mk2 vehicles as well as all Audi I5 20v motors w/o the camshaft position sensor (Will Not Fit AAN motor!). Made in USA. This cam gear also fits early 058 AEB and ATW 1.8t 20vt engines as well.
We stock this gear for fast shipment
NOTE, IT IS THE RESPONSIBILITY OF THE INSTALLER TO CHECK THE TIGHTNESS OF THE HARDWARE BEFORE RUNNING THE ENGINE